BCMSN Lab - Radius Server

Question:
CiscoSims is a small shipping company that has an existing enterprise network comprised of 2 switches, DSWI and ASW1. The topology diagram indicates their layer 2 mapping. VLAN 20 is a new VLAN that will be used to provide the shipping personnel access to the server. For security reasons, It Is necessary to restrict access to VLAN 20 in the following manner:

BCMSN LAB - Port Fast

Question:
You work as a network engineer at CiscoSims. The CiscoSims's Chinese office is installing a temporary catalyst 3550 in an IDF to connect 24 additional users. To prevent network corruption, it is important to have the correct configuration prior to connecting to the production network. It will be necessary to ensure the switch does not participate in VTP but forwards VTP advertisements received on trunk ports. All interfaces should transition immediately to the forwarding state of Spanning-Tree due to errors that have been experienced on office computers. Also, configure the user ports (All FastEthernet ports) so that the ports are permanently non·trunking.

BCMSN Lab - VTP and Vlans

Question:

You have just been hired by CiscoSims to help their main office expand. The main offices have enhanced their wiring closets with some layer 3 switches. The new distribution layer switch has been installed and a new access layer switch cabled next to it. Your task is as follow:

The information of the Question:

VTP Domain name: cisco
VlAN Ids : 20 31
IP Addresses : 172.16.71.1/24, 172.16.132.1/24

BSCI - OSPF Sim

Scenario:
OSPF is configured on routers Amani and Lynaic. Amani's S0/0 interface and Lynaic's S0/1 interface are in Area 0. Lynaic's Loopback0 interface is in Area 2.


Your task is to configure the following:

1. Portland's S0/0 interface in Area 1
2. Amani's S0/1 interface in Area 1
3. Use the appropriate mask such that ONLY Portland's S0/0 and Amnani's S0/1 could be in Area 1.
4. Area 1 should not receive any external or inter-area routes (except the default route).

BSCI - ISIS EIGRP Redistribution Sim

Scenario:
Portland Enterprises recently completed merging with Lynaic Endeavors. The two Companies have been using separate routing protocols on their corporate networks, and an immediate solution is required for the two companies to begin sharing data. A boundary router, Amadiya has been established to perform mutual redistribution of route information between the two networks. Configure route redistribution from EIGRP into IS-IS and from IS-IS into EIGRP on the boundary router per the following requirements:

BSCI IPv6 OSPFv3 Virtual Link Lab Sim

Scenario:
Acme is a small export company that has an existing enterprise network that is running IPv6 OSPFv3. Currently OSPF is configured on all routers. However, R4's loopback address (FEC0:4:4) cannot be seen in R1's IPv6 routing table. You are tasked with identifying the cause of this fault and implementing the needed corrective actions that uses OSPF features and does no change the current area assignments. You will know that you have corrected the fault when R4's loopback address (FEC0:4:4) can ping from R1 to R4 loopback address.

BSCI EIGRP Stub Lab Sim

EIGRP stub Lab

By increasing the first distant office, JS manufactures has extended their business. They configured the remote office router (R3) from which they can reach all Corporate subnets. In order to raise network stableness and lower the memory usage and broadband utilization to R3, JS manufactures makes use of route summarization together with the EIGRP Stub Routing feature. Another network engineer is responsible for the implementing of this solution. However, in the process of configuring EIGRP stub routing connectivity with the remote network devices off of R3 has been missing.